Know Your Environment. Protect Your Health.

Styrene

Plainview Municipal Water System

NOTE: Plainview Municipal Water System purchases water from Canadian River Mwa which is required to test for styrene. Sample information shown below was taken by Canadian River Mwa.

Styrene is a volatile cancer-causing chemical used for manufacturing Styrofoam (polystyrene) and other plastics. Releases from industrial production sites and hazardous waste landfills cause styrene contamination in drinking water. Read More.

In addition to increasing the risk of cancer, styrene can also damage the liver and the nervous system. California set a public health goal for styrene in drinking water at 0.5 parts per billion. The federal Maximum Contaminant Level (MCL) allows up to 100 parts per billion of styrene in water, which is 200 times more than the California recommended level.

Click here to read more about carcinogenic VOCs.

 

0

Samples

0

Samples exceeding legal limit (MCL)

0

Samples exceeding
health guidelines

Testing results - average by year

 
YearAverage resultSamples takenDetectionsRange of results
2020ND90ND
2021ND100ND
2022ND80ND
2023ND90ND
2024ND80ND
2025ND80ND

ppb = parts per billion

State, National, and Health Guidelines for Drinking Water

EWG Health Guideline: 0.5 ppb

The EWG Health Guideline of 0.5 ppb for styrene was defined by the California Office of Environmental Health Hazard Assessment as a public health goal, the level of a drinking water contaminant that does not pose a significant health risk. This health guideline protects against cancer.

EPA Maximum Contaminant
Level (MCL): 100 ppb

The legal limit for styrene, established in 1991, was based on a toxicity study in laboratory animals conducted in the 1970s. This limit may not fully protect against the risk of cancer due to styrene exposure.

ppb = parts per billion